- Disconnect power from the unit.
- Turn off water.
- Remove left panel and plexi-glass.
- Remove nuts holding down the coax to the mounting plate.
- Remove the two water lines that are connected to the coax mounts.
- Pull the screws from the mounting plate that holds the coax to the generator.
- Remove the three hoses that are connected from the generator to the coax and label them.
- Remove the ground cable and the coax handle cable.
- Your coax is now free.
- With a coil installed, blow air through all lines to clear all water.
- Replace coax following same procedures backwards.
-
- Remove left panel.
-
- Remove plexiglass.
-
- Remove ground and handle cable.
-
- This is how the coax should look like when removed from the cabinet.
Caution! Do Not cut the larger hose on the bottom. It has power leads in it!
Caution! Do Not cut the larger hose on the bottom. It has power leads in it!If you have questions or would like more help changing your cables, give us a call or send us a request. We’d be happy to walk you through the process.
You might also want to read:
Coil Installation Tips for Induction Power Supplies